Формат | Размер | Скачать |
---|
Название | : | |
Продолжительность | : | |
Пользователь | : | id 947481974494 |
Дата публикации | : | ript src= |
Просмотры | : | layer\/9383995e\/www-embed-player.vflset\/www-embed-player.js |
Понравилось | : | 1,312 |
Не понравилось | : | 57 |
Hi-yun-Day. 👍👍👍👍👍👍👍 Комментарий от : @shantellem4957 |
I have changed starter and crank shaft starter position sensor on my 2006 3.3 v6 I hook up co.outer and it doesn't throw a code on my obd ii scanner ughh I need help Комментарий от : @marthadavis9421 |
All these guys talk to damn much and still dont have a answer .... Комментарий от : @mauricearchie7399 |
have 07. Starter was the problem. Connections were corroded on the starter. Changed starter and cleaned rust off connections and no issues since. When you remove battery cable, do the work then start again, keep in mind it takes a few kms to reprogram the computer and it might run like crap for a bit. Just drive it, speed up, slow down, restart, etc. Computer needs to get engine info into it again, once it does, it runs fine. 10 min drive fixed this for me, no problems for a year, runs perfect, 0 issues. It's the starter or cable connections to the starter. Try polishing the connections with sand cloth or wire brush and you may not have to change the starter. Only access cables from under the car. Комментарий от : @warrenfahlman607 |
DID YOU FIND THE PROBLEM? Комментарий от : @luccyjayz |
So is getting the problem now?just curious about it Комментарий от : @sweetjordan4868 |
My girlfriend has an 06 sonata with the 3.3l. She had the same issue for about a year, I replaced the neutral safety switch myself to no avail, did the starter after and it’s been flawless about a year now. Комментарий от : @forrestmitchell8674 |